Completing a work within a day - or else not starting

Completing a work within a day - or else not starting

Postby usjung » Mon Nov 09, 2009 1:20 pm

Something went wrong, so I am posting it again.

I read your answer on how to make sure to start a work and finish the work by the end of the same day.

I put these logic in place, It is to feed the next work center only when there is enough time (8 hours) until the end of the day (the labor resource becomes unavailable at 19:00)


VL SECTION: Carrier Moving Forward Before Exit Logic
SET current_hour = HOUR[Simulation Time]
SET check_hour = current_hou2+8
IF check_hour <19
Select Current Work Item Carrier Moving Forward , 1
SET lbl time_control6_go = 1
ELSE
Select Current Work Item Carrier Moving Forward , 1
SET lbl time_control6_go = 0


I made a setting at Routing-out, by checking label and clicking detail to add lbl time_control6_go. Carrier Moving Forward is the name of the current work center.

From the top menu Results - Timeview function, i find the next work center performance is spread over two days for one item, which was I wanted to avoid.

Best Regards,

Unsuk

Return to “SIMUL8 Cafe”